2.
Press SETUP LABEL
"Display"
once
or
twice
3.
Press
"Autoscale".
Autoscale
is
aborted
by
pressing any
other
pushkey
before
the
auto-
scale's
completion.
During an autoscale, the message
"AUTOSCAL-
ING
IN
PROGRESS"
appears
on the 2032 Display.
"Format" - is used
to
select the
appropriate
display
format.
Where
no MEASUREMENT
SETUP is shown on the 2032 Display, the
possi-
bilities
are:
1.
Dual
trace
format,
trace
U and
L,
(U:
upper
trace,
L:
lower
trace)
2.
Full
format,
trace
U
3.
Full
format,
trace
L
Traces U and L are the
two
traces
defined by the
two
DISPLAY SET-
UPs in use.
If the MEASUREMENT SETUP is displayed, the
possibilities
are:
1.
Single
trace
U with the MEASUREMENT SETUP
2.
Single
trace
L with the MEASUREMENT SETUP
"Measurement setup" -
displays
the
current
MEASUREMENT SETUP
on the
lower
half
of
the 2032 Display. The
currently
displayed
MEA-
SUREMENT SETUP is always the one in use
during
an ongoing mea-
surement.
If the 2032 is in RECORD
"Stop",
any new measurement
will begin with the
currently
displayed MEASUREMENT SETUP.
Repeatedly
pressing
"Measurement
Setup"
toggles
the Display
be-
tween a dual
trace
or
single
trace
full
format
display
and a single
trace
format
display
with
the MEASUREMENT SETUP.
33
To Next Page
Loading...
