BRUEL & KJAER 2525 - Summary of Contents for Volume 2

Measuring Ampifier Type 2525
User Manual Vol.2
Brüel & Kjær
1–2
Chapter 1 – Introduction
About this Volume
1.1 About this Volume
This volume describes the programming and operation of the serial and parallel
interfaces of the Measuring Amplifier Type 2525. It is intended as a reference guide
for IEEE – 488/serial interface programmers and users. It is assumed that users are
familiar with manual operation of the analyzer, described in Volume 1 of this User
Manual, and have some experience in interface programming.
1.2 Summary of Contents
The following chapters describe the operation of the 2525 IEEE–488 and serial
interfaces.
● Chapter 2: Specifications and the set-up procedure for the IEEE–488 interface
● Chapter 3: Specifications and the set-up procedure for the serial interface
● Chapter 4: Interface message formats and some features common to both inter-
faces
● Chapters 5 and 6: How the individual messages are used in the control of data
flow between the 2525 and an interface controller
● Chapter 7: Syntax and format for measurement data
● Chapter 8: Interface error messages
● Chapter 9: Summary of interface commands
● Chapter 10: Index.