To Next Page

To Previous Page

Measuring Ampifier Type 2525

User Manual Vol.2

4–1

BE1394– 11

Chapter 4

Syntax and Data Types

4.1 Formats for Interface Messages............................................................................................. 4 – 2

4.2 Types of Data...................................................................................................................................... 4 – 6

4.3 Information Protocol ...................................................................................................................... 4 – 9

Table of Contents5
Introduction7
About this Volume8
Summary of Contents8
The IEEE - 488 Interface9
Interface Specifications10
Activating the IEEE Interface12
Local and Remote States12
Listening and Talking13
The Serial Interface15
Hardware/Functional Specifications16
Serial Interface Set-Up18
Syntax and Data Types21
Formats for Interface Messages22
Types of Data26
Information Protocol29
General Control Messages33
Introduction34
Remote/Local Set-Up34
Status and Configuration Check35
Error Check and Reset54
Set-Up and Display (Results) Messages59
Introduction60
The Channel_1 Header60
Measurement Set-Up Commands62
Display Set-Up Commands80
Lin./Db Read-Out82
Reference_Generator83
Si_Imperial_Units84
Decimal_Point85
Mounted Impulse/Resonance Frequency Commands86
Display_Mode88
6.11 Set-Up Memory Commands89
Back_Lighting90
Measurement Data91
Introduction92
Output Examples93
Interface Error Messages95
Error Handling96
Interface Errors97
Device Errors98
Command Summary99
Introduction100
Channel Independent Commands100
Channel_1 Dependent Commands102

Brand	BRUEL & KJAER
Model	2525
Category	Amplifier
Language	English

BRUEL & KJAER 2525 User Manual

Table of Contents

Other manuals for BRUEL & KJAER 2525

Questions and Answers:

BRUEL & KJAER 2525 Specifications

Related product manuals