BRUEL & KJAER 2525 - Error Check and Reset Procedures

Measuring Ampifier Type 2525
User Manual Vol.2
Brüel & Kjær
5–22
Chapter 5 – General Control Messages
Error Check and Reset
5.4 Error Check and Reset
5.4.1 Reset
Reset_Single
The Reset_Single command allows you to reset the alarm detector (Alarm), the
measurement channel parameters (Channel), the detectors alone (Detectors) or the
event/event enable registers as shown in Fig.5.18.
Resetting the detectors or channel will cause no interruption in the current meas-
urement.
Reset
The Reset command provides more comprehensive reset options than Reset_Single.
All_Event_Registers and All_Event_Enable_Registers reset the
Measurement_Status and the Operation_Complete Event and Event Enable Regis-
ters respectively.
You can reset the Status_Byte or the entire System using Reset, as shown.
Fig.5.18 Syntax for Reset_Single command
941143e
CHANNEL_1 RESET_SINGLE
To 2525
: SP
—
:
CHANNEL
DETECTORS
OPERATION_COMPLETE
OPERATION_COMPLETE_ENABLE
MEASUREMENT_STATUS_ENABLE
MEASUREMENT_STATUS
ALARM
Te