Need help?Do you have a question about the BRUEL & KJAER 2525 and is the answer not in the manual?
General| Gain | 0 dB to 50 dB in 10 dB steps |
|---|---|
| Output Impedance | 50 Ω |
| Maximum Output Voltage | 10 Vrms (28 V peak-to-peak) |
| Noise | <5 μV |
| Input Impedance | 1 MΩ |
Provides a brief overview of the chapters and topics covered in this volume of the user manual.
Details the functions implemented and interface connections for the IEEE 488 standard.
Describes the steps required to enable and activate the IEEE 488 interface for operation.
Details the physical characteristics, pin definitions, and data lines of the serial interface.
Explains how to configure baud rate, handshake, and echo settings for the serial interface.
Defines terminology and structure for messages exchanged via the interface.
Describes character, numeric, and string data formats used in interface commands and queries.
Covers commands for checking measurement status, operation complete, and device configuration.
Details commands for checking error status and performing various reset operations.
Commands for configuring measurement parameters like mode, sensitivity, input type, and gain.
Commands to configure display parameters, including measurement results shown.
Provides examples of current and all data outputs from the amplifier.
Explains how the amplifier handles interface and device errors and how to check them.
Details specific error codes and descriptions for interface-related issues.
Lists commands that control amplifier functions without channel-specific parameters.
Lists commands that require channel-specific parameters, typically Channel_1 for this model.
To Next Page
