Measuring Ampifier Type 2525
User Manual Vol.2
Brüel & Kjær
8–4
Chapter 8 – Interface Error Messages
Device Errors
8.3 Device Errors
Message Description
Type/
Number
Vector sum is not permitted
with different RMS averaging
time or mode
The RMS averaging time and mode must have the same value
for all channels in a vector sum. This message is only relevant
for amplifiers with more than one channel (not the 2525).
100
Vector sum is not permitted
with different Measurement
mode
The measurement mode must be the same for all channels in a
vector sum. This message is only relevant for amplifiers with
more than one channel (not the 2525).
101
Vector sum is not permitted
with
Display_Mode: Digits_And_Sele
ct
The vector sum requires more than one measurement parame-
ter displayed. This message is only relevant for amplifiers with
more than one channel (not the 2525).
102
Same parameter is used more
than once in Display_Set_Up
Only different measurement parameters may be used for
Display_Set_Up
103
Interface command is not
allowed with a 1 channel ver-
sion
The interface message used relates to an amplifier with more
than 1 channel (not the 2525).
104
To Next Page
Loading...
Need help?
General
