Brusa ICS115 - 12.6 GPM Deinstallation; 12.6.1 Deinstallation Procedure for GPM (Customer Service)

WORK STEP ILLUSTRATION / OTHER INFO
4
Transport: Transport the GPM, so that you
can move comfortably. As a result you
avoid posture injuries. Use auxiliary
equipment to protect the transport, such as
handcart and lashing straps.
Note the weight and center of gravity of the GPM.
5
Setting down: Place the GPM (possibly in
packaging) on a level surface.
Ensure compliance with the conditions in chapter 12.5.8 for
storage or transport of the GPM.
6
Storage: Store the GPM (possibly in
packaging) horizontal on level surfaces.
Place the base area of the GPM (possibly
in packaging) completely on the storage
surface.
Avoid damage to the GPM due to
incorrect storage.
Observe the conditions in chapter 12.5.8.2
for the storage of
the GPM.
12.6 Deinstallation of the GPM
The deinstallation of the GPM component may only be performed by specialist personnel. Contact customer
service.
12.6.1 Procedure for the Deinstallation of the GPM (Information for Customer Service):
WORK STEP ILLUSTRATION / OTHER INFO
1
Ensure for a safe working environment
during the deinstallation.
Inform the people
in your surrounding area about your work.
Ensure for adequate lighting.
If the GPM is hot, wait until it has cooled
down.
Make sure, that no sources of danger can occur
during the
deinstallation (e.g. for pets, crushing by machines). Do not wear
any jewelry during the deinstallation.
Danger of injury with hot GPM.
2
Switch off the power supply for the GPM.
3
Make sure by means of measurement, that
the power supply for the GPM is switched
off.
Use suitable tools to check the voltage.
4
Disconnect the GPM from the connection
to the power supply.
5
Stow the GPM safely for removal.
Take into consideration the instructions for transport and
storage in chapter 12.5.8 .
Operation Manual
Inductive Charging System
ICS115
54