Brusa ICS115 - 12.7 CPM Vehicle Integration; 12.7.2 CPM Mounting

WORK STEP ILLUSTRATION / OTHER INFO
6
Clear the charging system of tools and
auxiliary equipment that was used during
the assembly and installation.
Do not forget any utensils, that you have required for the
assembly and installation of the CPM. Do not leave any
waste behind (packaging material) with the user of the ICS.
7
Dispose of the GPM taking into
consideration the instructions for the
disposal of electrical devices in chapter
10.1.
12.7 Vehicle Integration of the CPM
12.7.1 Installation Information
The electrical, mechanical and thermal integration of the CPM is to be ensured by the vehicle manufacturer.
12.7.2 Mounting the CPM
Observe the following points for the mounting of the CPM:
 The CPM must be installed at a dry location.
 The mechanical fastening must be positioned, so that the device is installed firmly and with as little
vibration as possible.
 Cable feeds must not bunch up on sharp-edged components.
 The CPM is to be installed at the three fastening points illustrated:
55
Operation Manual
Inductive Charging System
ICS115