Brusa ICS115 - 13 Annex A2; Standards and Legal Requirements

13 Annex A2
13.1 Standards and Legal Requirements
The standards and legal requirements that the ICS product fulfills, are compiled in the following table:
Table 3: Standards
NO REQUIREMENT CONTENT
1
2014/53/EU
Provision of radio equipment on the market
2
2011/65/EU
Restriction of Hazardous Substances - RoHS
3
EN 55011:2009+A1:2010
Industrial, scientific and medical equipment - Radio-frequency disturbance
characteristics
- Limits and methods of measurement
4
EN 61000
-3-2
:2014
Electromagnetic compatibility (EMC) – Part 3-2: Limits - Limits for harmonic current
emissions
5
EN
61000-3-3:
2013
Electromagnetic compatibility (EMC) – Part 3-3: Limits - Limitation of voltage
changes, voltage fluctuations and flicker
6
EN 61000-6-
2:2005
+AC:2005
Electromagnetic compatibility (EMC) – Part 6-2: Generic standards - Immunity for
industrial environments
7
EN 300 328 V2.1.1
Wideband transmission systems - Data transmission equipment operating in the
2.4 GHz ISM band and using wide band modulation tech
niques
8
EN 300 330 V2.1.1
Electromagnetic Compatibility and Radio Spectrum Matters (ERM) - Short Range
Devices (SRD)
9
EN 301 489-1 V2.1.1
Electromagnetic compatibility and Radio spectrum Matters (ERM); Electromagnetic
Compatibility (EMC) standard for radio equipment
10
EN 301 489-3 V2.1.1
Electromagnetic compatibility and Radio spectrum Matters (ERM); Electromagnetic
Compatibility (EMC)
standard for radio equipment and services
11
EN 301 489
-17
V3.2.0
Electromagnetic Compatibility (EMC) standard for radio equipment and services -
Part 17: Specific conditions for Broadband Data Transmission Systems
12
EN 50364:2010
Limitation of human exposure to electromagnetic fields from devices
13
EN 62479:2010
Assessment of the compliance of low power electronic and electrical equipment
with the basic restrictions related to human exposure to electromagnetic fields (10
MHz to 300 GHz)
Operation Manual
Inductive Charging System
ICS115
64