25
5.6. Searching for Zones (If Applicable)
“Zoning - Searching” will appear on the screen to determine if any zones
are present. The screen will show Zone 1, Zone 2, etc. and indicate all
zones having either a Remote Room Sensor, or smart sensors associated
with them. If the system contains smart sensors, they must be assigned a
zone number before continuing. See the Smart Sensor Installation
Instructions on how to assign Smart Sensors to their respective zones.
After each zone has been identified, touch NEXT.
A12185
5.7. Filter Type Selection
The installer will next be prompted to select the air filter type installed
with the Evolution System. After the selection is made, touch NEXT.
• Air Filter: 1-in. to 4-in. media filter
• EAC: high voltage electronic air cleaner
• Air Purifier: Evolution Series or Preferred™
5.8. Humidifier Installation
Next, the installer will be prompted to select whether a humidifier is
installed in the system. Select YES or NO, then touch NEXT.
To Next Page
Loading...
Need help?
General
