33
6.3.1.3. Offsets
This option allows calibration (or deliberate miscalibration) of the
temperature and humidity sensors. These offsets are added to the actual
temperature/humidity values. See also Zone Offsets Section. When the
correct offsets are made, touch SAVE. If the system is non-zoned, the
indoor temperature offset is found on this screen. If the system is zoned,
the indoor temperature offset is found in the Zoning, Offsets screen.
• Outdoor temperature: Adjustable from -5 to 5°F (-3 to 3°C).
Default = 0°F
• Indoor temperature: Adjustable from -5 to 5°F (-3 to 3°C).
Default = 0°F
• Humidity: Adjustable from -10 – 10%. Default = 0%
NOTE: For single-zone systems, the indoor temperature offset is on this
screen. For zoning systems, there is a separate zone indoor temperature
offset screen in the zoning menu.
A190275
6.3.1.4. Reset Factory Defaults
This option allows the installer to reset certain factory parameters. After
the selections are made, touch SAVE.
• Program Schedule: Reset back to pre-programmed time and
temperature.
• User Settings: Reset user settings back to pre-programmed values.
6LQJOH]RQH6\VWHPV =RQLQJ6\VWHPV =RQLQJ6\VWHPV
To Next Page
Loading...
Need help?
General
