58
A13122A
6.4.1. Electric Heat
If you have a fan coil with electric heaters, this menu item will allow the
heaters to be exercised. With self-identifying electric heaters, three stages
of electric heat are available to be exercised in any combination.
Non-identifying heaters will only provide one stage of heat; or perhaps
may have fixed-timed staging. See the instructions provided with the
electric heat accessory. After the selections are made, touch START.
• Low Heat: Selectable from 0 to 120 minutes. Default = 5 minutes
• Medium Heat: Selectable from 0 to 120 minutes. Default = 5 minutes
• High Heat: Selectable from 0 to 120 minutes. Default = 5 minutes
6.4.2. Furnace
Make sure the furnace is properly installed.
This option allows the furnace to be exercised. First, a low heat run time
and high heat run time are selected. The furnace will execute its ignition
start-up sequence. This sequence will be displayed on the screen. After
the gas valve and blower motor turn on, the screen will show the current
operating status of the furnace. After the selections are made, touch
START.
• Low Heat: Selectable from 0 to 120 minutes. Default = 5 minutes
• High Heat: Selectable from 0 to 120 minutes. Default = 5 minutes
To Next Page
Loading...
Need help?
General
