If you experience any problems, please call the Helpline on Freephone 0800 145 6789* or email
When you make a call, the green In
Use light on the base ashes.
Your handset will automatically time
the duration of all external calls.
The handset display shows the call
duration both during and for a few
seconds after your call.
During a call, you can open the
phonebook by pressing Names.
1. In standby, press and hold to switch the handset off.
When off, press
to switch back on, or put the handset
back on its base.
1. Press .
2. When you hear the dial tone, dial the number.
1. Dial the number rst. If you make a mistake press Clear to
delete the last digit.
2. Press
to dial.
1. Press .
Once you’ve pre-dialled a number, you can select Options
to either save the number to your phonebook or to use when
sending a text message.
When you receive an external call, the phone rings. The display
shows External Call and the caller’s number or, if the number
matches an entry stored in the phonebook, the name is displayed.
1. If your handset is on the base and Auto Talk is on, pick up
the handset.
Or
If your handset is on the base and Auto Talk is off, pick up the
handset and press
.
Or
If your handset is off the base, press
.
When the handset moves out of
range of the base, the screen shows
Searching… the ashes and the
handset gives a warning beep.
If you are on a call, the line will
hang up. Move back within range.
The handset will automatically
re-connect to the base.
If auto talk is set to ON you can just pick
the handset up to answer a call.
If you have switched auto talk off,
you will need to press
as well.
Auto Talk ON is the default setting.
To switch Auto Talk on and off, see
page 25.
During Preparatory dialling (but
before pressing the
button) you
can press Options to either save the
number to the phonebook or to send
a text to that number.
To Next Page
Loading...
