BTech DMR-6X2 CodePlug Programming Guide
V-1.00/1.00
Page 10 of 30
© 2017/8 Trygve Svärd KD0PNQ
STEP 6 – RECEIVE GROUP CALL LIST SET-UP
You can leave this blank if all you want to do is to listen to the same channel that you
transmit on. Then under Channel set-up in the section below you select “NONE” for the
Receive Group List. Your receive TG will now default to the transmit TG.
If you want to listen to additional TG’s on a channel, add the TG in the Receive Group
Call List. Under Channel set-up in the section below, select the name of the Group List.
You can program up to 64 TG’s per receive group.
Note: If the Talk Group List contains a TG with the same number as another one, then
this Receive Group List will not work.
To Next Page
Loading...
