BTECH DMR-6X2 - On-the-Fly Talk Group Selection; Talk Group Selection Procedure; Talk Group Operation Modes

BTech DMR-6X2 CodePlug Programming Guide
V-1.00/1.00
Page 29 of 30
© 2017/8 Trygve Svärd KD0PNQ
Cross Band repeat is also possible with two channels on alternate
frequencies. The image at the right shows setup. If either the A
(upper) or B (lower) receives a transmission, it will forward it to the
opposing frequency when the transmission is complete.
6.2 On the Fly Talk Group Selection
If you want to switch to a talk group not currently in your code plug. This can be done
quickly using the keypad. This is especially useful when using a hotspot.
Setup Procedure
Under Optional Settings / Key Function
- Assign a Programmable Key to “Dial”
Under Optional Settings / Digital Func
- Set Group Call Hold Time > Unlimited
- Set Person Call Hold Time > Unlimited
Operation
- Select a channel that is already set to the proper Freq and Time Slot.
- Activate the ‘Dial’ function (Private ID will appear on the LCD)
- Press the ‘#’ key (Group ID will now appear on the LCD)
- Enter the desired Talk Group using the number pad
- Press the PTT switch to activate
The radio will stay on that talk group until a different channel is selected. This is the
desired mode for ham operation. There are other Hold Time options that will return the
radio to its original channel after a short period of time.