BTech DMR-6X2 CodePlug Programming Guide
V-1.00/1.00
Page 26 of 30
© 2017/8 Trygve Svärd KD0PNQ
4.1 DMR-6X2 RADIO TOTAL SYSTEM RESET
NOTE: Always save a copy of your current code plug!
If the DMR-6X2 radio becomes inoperative, a Total Reset may be required. This is not
recommended if the radio operates properly. It is only used as a final solution for a
major issue, or the firmware upgrade requires it.
To reset the radio:
- Power the radio ON while pressing the PTT and the PF1 button (below the PTT) at
the same time.
- If asked to confirm a full reset is desired, reply Confirm.
- The radio will Restart displaying start up displaying ”MCU Reset, Please Wait”
- Do Not turn OFF the radio while restarting.
After a re-start, the radio will display the setting for time zone, the date and the time.
- Use the up-down key to set the current time zone.
- Move to the year by pushing the P1 key.
- Set the year, and use the P1 key to move forward each step.
- When complete, click the Menu key to save the time zone, date and time.
You may now see the Chinese language. If it starts with Chinese:
- Click Menu
- Scroll down to the grey cogwheel (Settings)
- Select 1 (Radio Set)
- Select 11 (Language)
- Select 1 (English)
The codeplug has also been replaced as part of the system re-set. You will now need to
re-load your saved codeplug into the radio. Remember to update your DMR ID number
and the start-up display if you use a codeplug from the Internet.
4.2 DMR-6X2 RADIO ICON - Firmware Update
NOTE: This is a very rare update but may be require to be done!
- Download the special firmware files from the BTech website.
- Perform the update procedure described in Section 4.0 above.
To Next Page
Loading...
