BTECH DMR-6X2 - Step 8: Configuring Optional Settings; Work Mode and VOX Settings; FM, Power Save, and Key Function Settings

BTech DMR-6X2 CodePlug Programming Guide
V-1.00/1.00
Page 13 of 30
© 2017/8 Trygve Svärd KD0PNQ
STEP 8 - OPTIONAL SETTING
The DMR-6X2 radio basic configuration set-up is done in the Optional Setting window.
This page contains a lot of important information for the radio operation.
Once the Optional Setting window is open, there are several sub-sections to program.
The above window shows all the 10 sub menus available in the Optional Settings.
Work Mode
Display Mode Defines what the radio display will show when in receive mode –
frequency or channel name
VF/MR (A) Select VFO or MEM for the “A” upper channel
MEM Zone (A) Select the initial Zone to appear at power up.
VF/MR (B) Select VFO or MEM for the “B” lower channel
MEM Zone (B) Select the initial Zone to appear at power up
Main Channel Set Select “A” or “B” as the main channel
Sub-Channel Mode Select OFF if only the “A” channel is to be used; ON for both A+B
VOX
VOX Level Select VOX sensitivity. OFF, 1, 2, 3
VOX Delay Select delay time in seconds. .5, .6 > 3.0s
VOX Detection Select internal Micr, Spkr/Micr, or Both
SQUELCH TAIL ELIMINATE (STE)
STE Type of CTCSS Select Off, Silent or a selected setting
STE When No Signal Select Off, 55.2Hz, or 259.2Hz
FM
FM VFO/MEM Select VFO or Memory mode
FM Work Channel Select the initial FM channel (after set-up done)
FM Monitor When in FM mode, select ON if radio is to receive calls