BTECH DMR-6X2 - Step 13: Hot Key Programming; Hot Key Functionality

BTech DMR-6X2 CodePlug Programming Guide
V-1.00/1.00
Page 20 of 30
© 2017/8 Trygve Svärd KD0PNQ
Emergency Alarm Select from Alarm, Transpond + Background, Transpond + Alarm,
or Both
ENI Type Selected Select from None, DTMF or 5Tone
Emergency ID When ENI Type choose DTMF or 5Tone, you should edit the DTMF
or 5Tone firstly, then choose the required number in this column
Alarm Times Select after what time the alarm should be initiated
Duration of TX Select the duration of the Alarm transmission
Duration of RX Select the duration of listening mode after an alarm reset
Emergency ENI Select which channel the Alarm should be sent out on
Emergency Ch. Select which channel to use
Emergency Cycle Select Continuous or a time
NOTE: A channel is the No. on the Channel Menu line for the selected frequency.
Work Alone
Response Time Select the time for the radio to respond to an Alarm trigger
Warning Time Select the duration if a warning transmission
Response Select Key or Voice for a response to reset
Digital Alarm
Emergency Alarm Select one of 4 options for how to initiate an Alarm
Alarm Time Select after what time to initiate the Alarm
Duration of TX Select the duration of the Alarm transmission
Duration of RX Select the duration of listening mode after an alarm reset
Emergency ENI Select which channel the Alarm should be sent out on
Emergency Ch. Select which channel to use
Emergency Cycle Select Continuous or a time
TG/DMR ID Enter ID/Talk Group to be contacted
Call Type Enter Group or Private
Enter OK to save.
LOCAL INFORMATION
Displays the USB COM port information
STEP 13 - HOT KEY
The Hot Key programming offers 3 sub-windows within the Hot Key Edit window.