BTECH DMR-6X2 - Spread Sheet Option

BTech DMR-6X2 CodePlug Programming Guide
V-1.00/1.00
Page 12 of 30
© 2017/8 Trygve Svärd KD0PNQ
Talk Around Check for RX freq. the same as the TX freq. (Simplex).
Through Mode
Digital
Contact Select the Talk Group this frequency belongs to
DMR/Radio ID Select which of the DMR ID’s to use for this channel
Color Code Select which CC is related with this channel
Slot Select which slot (1 or 2) applies to this “Channel”
Receive Group List If programmed, select the Talk Group List desired. Select
NONE if Transmit and Receive TG the same.
Digital Encryption Select Off or which number to use for encryption
Encryption Type Select desired encryption method.
TDMA Check if working dual time slot simplex
TDMA Adaptive Check if for adaptive slot selection between slot 1 and 2
Call Confirmation Check if the receiver needs to transmit before accepting
private calls
Ranging: Check if GPS ranging between two radios is desired
Analog
CTCSS/DCS Decode Select Off or CTCSS or DCS and tone frequency
CTCSS/DCS Encode Select Off or CTCSS or DCS and tone frequency
Squelch Mode Select how to use the squelch
Optional Signal Select Off, DTFM, 2Tone or 5Tone
DTFM ID Select DTFM ID
2Tone ID Select 2 Tone ID
5Tone ID Select 5 Tone ID
Custom CTCSS Enter value when requiring a custom CTCSS tone
PTT ID Select off, at start, at end, or both
Once completely filled in, click OK to save this Channel.
Spread Sheet Option
For large amounts of channel data, this may be a desired method as it allows cut and
paste of large amounts of data. This is especially desired when adding multiple
repeaters with similar configurations.
The current channel configuration can be exported to a csv file, enhanced, then
imported back to the code plug.
Always save data files for recovery purposes.