BTech DMR-6X2 CodePlug Programming Guide
V-1.00/1.00
Page 24 of 30
© 2017/8 Trygve Svärd KD0PNQ
indications can appear:
• Reception bars left side is showing signal strength
• Within a square “L/M/H/T” transmit power levels showing from Low to Turbo
• Speaker = Digital Monitor is turned on for 1 or 2 slots (promiscuous mode)
• Microphone = You have turned On the recording feature of the radio (8 hours)
• GPS symbol gray = no GPS signal received, red = GPS signal received
• “A” indicates a set-up for Automatic Power Off
• CC11 for Digital reception shows the Color Code for the primary channel
• DCS or CTC for Analog reception indicates a tone signaling squelch
• The date line changes and shows sequentially date/last heard/current TG
• DIG/ANA CH-796 – shows the channel type and number of the channel.
• T1 or T2 time slot shown for the digital channel used as “A” and/or “B”
• R next to a digital channel = repeater with different RX and TX frequency. A red
R indicates reversed RX and TX frequencies.
To Next Page
Loading...
