Bucher Municipal
V Range
Routine Maintenance
123
V50 • V65 • V80 Operator’s Guide
Service A - Every 500 Hours - To be carried out by workshop personnel.
1. Change auxiliary engine oil and renew filter.
2. Renew the fuel filter element.
3. Renew auxiliary engine air cleaner elements.
4. Check auxiliary engine throttle control and engine idle for correct operation.
5. Clean duct in body roof.
6. Check the fluid flywheel oil level.
7. Check auxiliary engine coolant concentration gives -39°C frost protection.
8. Check Supawash pump (if fitted) for the correct operation of jets and any plunger
seal leaks. Service as necessary.
Service B - Every 1000 Hours - To be carried out by workshop personnel.
1. Carry out 500 hour service; plus:
2. Renew hydraulic return filter element.
3. Renew water pump suction filters.
4. Replace fuel pre-filter (JCB 55kW S5 engine only).
5. Carry out a visual inspection for the security of body mounts, pivot pins and
equipment. - Ensure torque identification marks are aligned - re-torque as required
(See torque chart in maintenance manual)
Service C - Every 2000 Hours or 1 Year - To be carried out by workshop personnel.
1. Carry out 1000 hour service; plus.:
2. Drain and refill hydraulic reservoir.
3. Clean/replace suction filters and refill hydraulic reservoir.
4. Check valve clearances on the auxiliary engine if applicable.
5. Oil filler and dipstick O-rings, change.
6. Drain and refill ‘Z’ drive gearbox.
7. Replace Auxiliary engine drive belts.
8. Drain and refill Supawash pump (if fitted).
Service D - Every 4000 Hours or 2 years
1. Carry out 2000 hour service; plus.:-
2. Drain and refill fluid flywheel.
A
B
C
D
Vt - Twin Engine
NOTICE
Used oils and filters should be disposed of in accordance with local waste disposal
regulations.
To Next Page
Loading...