Advanced programming options
9
Logamatic 2107 controls - We reserve the right to make any changes due to technical modifications.52
Turn the dial until the switching point of the heating phase that you wish to
connect to another is displayed (in this case "1.00pm").
+
Hold down the "Time" key and turn the dial to the desired value (in this case
"5.00pm").
The switching point cannot be turned any further since another switching point
is programmed at 5.00pm.
Once you have turned to the "5.00pm" switching point, the display changes to
"CONNECT" and an "8" appears for each numerical value in the display. Each
"8" disappears after a short time.
Once all eight have disappeared, you can release the "Time" key. The two
switching points "1.00pm and 5.00pm are deleted and the new program is
programmed with a continuous heating phase from "11.30am – 11.00pm" and
stored under "OWN PROGRAM 1".
USER NOTE
Cancelling the deletion
Release the "Time" key before all the eights have disappeared. The switching
points of the heating phases are retained.
Press the "AUT" key to return to the standard display.
To Next Page
Loading...
Need help?
General
