Buderus Logamatic 2107 - Advanced Programming Options; Modifying Standard Heating Programs

Advanced programming options
9
Logamatic 2107 controls - We reserve the right to make any changes due to technical modifications. 45
9 Advanced programming options
9.1 Modifying standard programs
If a standard program only partly meets your needs, you or your heating
contractor can modify it. The modified standard program is stored under the
name "OWN PROGRAM".
A standard program is determined by switching points, and each switching point
is defined by three things: "Day", "Time" and "Temperature". The higher
temperature set corresponds to "Day mode ON", while the lower value equates
to "Night mode OFF". The switching points indicate the start and end of normal
heating mode (day mode).
Example
In the Family program, we are moving the heating ON time for heating zone 2
on Monday from 5.30am to 6.30am (Fig. 13).
Fig. 13 Changing the switching point
Before:
Night mode
Day mode
Night mode
After:
5.30am
11.00pm
5.30am 6.30am 11.00pm
Day mode