Troubleshooting
10
Logamatic 2107 controls - We reserve the right to make any changes due to technical modifications. 55
10 Troubleshooting
If faults occur in the heating system, they are displayed
on the controls.
You can remedy some faults yourself (see chapter
"Fault table" page 56). You may have to switch the
heating system to emergency mode (see chapter 11
"Operation in the event of a fault" page 58).
If you cannot remedy the fault yourself, please follow
these instructions:
z Check whether there is a fault message on the
controls’ display.
z Report the fault initially by telephone to your heating
contractor.
Have the faults remedied by your heating contractor
immediately.
To Next Page
