Buderus Logamatic 2107 User Manual

Basic functions
6
Logamatic 2107 controls - We reserve the right to make any changes due to technical modifications.24
6.5 Setting the room temperature
If no remote control is connected, you can enter your room temperature for
normal heating mode (day mode) and setback heating mode (night mode) on the
controls.
If there are two heating zones connected without remote control, the settings on
the controls apply to both heating zones.
If no remote control is installed, the desired room temperature, rather than the
measured room temperature, appears on the display.
Never overheat rooms; overheated rooms are unhealthy and waste money and
energy.
A comfortable room climate depends not only on the room temperature but also
on the relative humidity.
70°F (21°C) is set at the factory for the normal heating mode (day mode) and
63°F (17°C) for setback heating mode (night mode).
If a remote control is connected, it can only be used to set the room temperature
for normal heating mode (day mode) and setback heating mode (night mode) for
the associated heating zone.
As soon as an operating mode key is pressed on the controls, "REMOTE"
appears to indicate that a remote control is connected. The "AUT", "Day mode"
and "Night mode" keys on the controls are disabled for this zone and replaced
by the keys on the remote control.
Only the temperatures that were set via the remote control appear on the
Logamatic 2107 display.
REMOTE 1
AUTOMATIC
11.15am
70

Buderus Logamatic 2107 Specifications

General

Category	Control Systems
Type	Heating Control Unit
Voltage	230 V
Frequency	50 Hz
Protection class	IP20
Ambient temperature	0°C
Application	Heating systems