Operation in the event of a fault
11
Logamatic 2107 controls - We reserve the right to make any changes due to technical modifications. 59
In the event of faults, immediately notify your heating
contractor. It would be helpful for your heating contractor
if you could provide him with precise details about the
fault.
Operation
In manual mode, the pumps for the heating
circuit(s) and the DHW tank filling pump are
switched on constantly. The recirculation
pump remains switched OFF.
WARNING!
RISK OF SCALDING
The DHW temperature can be set to a
maximum of 194°F (90°C). At DHW
temperatures over 122°F (50°C) there is a
risk of scalding at the taps if the DHW line
has no thermostatic mixing valve installed.
z If the DHW temperature is set to above
122°F (50°C), you should only draw off
mixed hot and cold water.
To Next Page
Loading...
Need help?
General
