Buffalo LinkStation - System - Maintenance; E-mail Notification

Using your LinkStation
LinkStation User Manual 84
RAID Scanning
LinkStations that are in RAID 1 mode support RAID scanning. A RAID scan tests the RAID array for
read performance. If defective sectors are found, they are repaired automatically. If your multiple-
drive LinkStation is in RAID 1 mode, you should run RAID scans regularly. Congure regular RAID
scans as follows:
1
2
Notes: Check [Shutdown] to automatically shut down the LinkStation whenever a RAID error
occurs. Check [Begin Immediate RAID Scan] to initiate an immediate RAID scan.
To stop a RAID scan, click [Abort RAID Scanning].
Single-drive LinkStations do not support RAID arrays or RAID scanning.
RAID Scanning is now congured.
Choose [Enable], enter your desired schedule, and
click [Save].
Navigate to [System] - [Storage] - [RAID Scanning]
in the Web Admin interface. Under [RAID
Scanning], click [Modify Settings].