Enter the type of standard signal used in this menu item. You can select between the following standard signals:
0 ... 5 V,•
0 ... 10 V,•
0 ... 20 mA,•
4 ... 20 mA.•
InP (Input) - Selection of the input signalFigure 15:
In this menu the electronics are adjusted to
the valve used and•
the fluidic conditions in the application.•
Absolutely vital are
the setting of the valve type in the sub-menu VALV and•
the setting of the working range of the coil current in the sub-menu AdJ.•
The modifications of the PWM control frequencies possible in the sub-menu VAdJ compared with the default
values defined with the selection of the valve type are only necessary in special applications.
To Next Page
Loading...
