Before loosening the lines and valves, turn off the pressure and vent the lines.•
Before reaching into the device or the equipment,• switch off the power supply and secure to prevent
reactivation!
Observe applicable accident prevention and safety regulations for electrical equipment!•
Installation may be carried out by authorised technicians only and with the appropriate tools!•
Secure system from unintentional activation.•
Following assembly, ensure a controlled restart.•
Before reaching into the device or the equipment,• switch off the power supply and secure to prevent
reactivation!
Observe applicable accident prevention and safety regulations for electrical equipment!•
The electrical connection of the Controller Type 8605 in cable plug version is made via a 4-pin terminal strip inside
the device.
Cable:
Diameter 6 ... 8 mm•
Cross-section max. 0.75 mm²•
Cable connections Cable gland or plug connector M12 •
4-pin
To Next Page
Loading...
