Busch-Jaeger Busch-Timer 6455 - Return Pulse

Operating Instructions
Busch-Timer
®
Operation
Operating Instructions | 1473-1-8164
— 23 —
Pos: 80 / #Ne ustr ukt ur# /Onl in e-Do kume ntati on (+ KNX) /Üb ersc hr ift en ( --> Für all e D oku ment e <--)/3. Ebene/P - R /Rückf ahri mpuls @ 28 \mod_1347002347378_15.docx @ 231978 @ 22222 @ 1
5.9.2 Return pulse
Pos: 81 / #Ne ustr ukt ur# /Onl in e-Do kume ntati on (+ KNX) /B edie nung /Ti mer/ Ein st ellu ngen - Sonderfunktionen - Rückf ahri mpuls - 645 5 Jalous ie @ 26 \mod_1343815961406_15. docx @ 2 264 44 @ 2 @ 1
With function "Return pulse" you can let the blind move up from the bottom end position until the ventilation slots
are open. With this function the blind is, after closing (DOWN command), moved in the UP direction for the set
time.
The adjustment range lies between 0 and 255.
Setting
Meaning
0
No return pulse
255
Maximum duration, corresponds to around 30 seconds
The return pulse is executed only if the blind was started previously from the top end position.
The return pulses can be entered separately for the following functions:
• Switching times
• Additional switching times (if active)
• Twilight function (only with sensor)
Fig. 16: Menu item – Return pulse