GasAlertMax
Safety Information - Read First
5
D1430/2 English
Caution (cont.)
To avoid possible damage to the detector:
⇒ Extended exposure of the GasAlertMax to certain concentrations of combustible gases and air may stress a
detector element, which can seriously affect its performance. If an alarm occurs due to high concentration of
combustible gases, recalibration should be performed, or if needed the sensor replaced.
⇒ Exposure to some substances (e.g. silicones, phosphates, lead or sulfur containing compounds) can cause LEL
sensor sensitivity loss.
⇒ Do not test the combustible sensors response with a butane cigarette lighter; doing so will damage the sensor.
⇒ Do not expose the detector to electrical shock and/or severe continuous mechanical shock.
⇒ Do not attempt to disassemble, adjust, or service the detector unless instructions for that procedure are
contained in the manual and/or that part is listed as a replacement part. Use only BW Technologies
replacement parts.
⇒ Do not immerse the detector in liquids.
⇒ The detector Warranty will be voided if customer personnel or third parties damage the detector during repair
attempts. Non-BW Technologies repair/service attempts void this Warranty.
Table 2. International Symbols
Symbol Meaning
Approved by Canadian Standards Association to both U.S. and Canadian Standards
European Explosion Protection
X
XX
X
Conforms to European Union directives
BAM
BAM performance verification and expert opinion (in progress)
ATEX
Conforms to European ATEX Directive 02 ATEX 6103X ATEX g II 2G
AUS
Certified to Australian standards
To Next Page
Loading...
