GasAlertMax
User Manual
34
D1430/2 English
Maintenance
To keep the detector in good operating condition, perform the
following basic maintenance as required:
• Calibrate, test, and inspect the detector at regular
intervals.
• Keep an Operations Log of all maintenance, calibrations,
and alarm events.
• Clean the exterior with a soft damp cloth. Do not use
solvents, soaps, or polishes.
• Do not immerse the detector in liquids.
Replacing the Battery
a Warning
To avoid personal injury:
⇒ Replace the battery as soon as the detector emits a
Low Battery Alarm.
⇒ Use only Black & Decker VersaPak™ batteries,
properly installed in the detector case.
⇒ Only charge batteries using a VersaPak™ charger
(such as the D4-VP130 or V-CHARG1). Do not use
any other charger. Failure to observe this precaution
could lead to fire or explosion.
⇒ Do not change or charge batteries in a hazardous
location. Doing so will impair the intrinsic safety of
the unit, and may lead to fire or explosion.
⇒ Before you use the detector for the first time, fully
charge the batteries, following the instructions
provided with the charger.
To Next Page
Loading...
