GasAlertMax
Deactivating the Detector
13
D1430/2 English
Sampling Pump Test
The pump is tested continuously after activation. If the pump
fails the display will show:
Note
If Pump Alarm continues for more than 5 seconds
and the display advises Inlet Blocked, see “Pump
Calibration”.
Battery Test
The battery is tested on activation and continuously after
activation. If the battery is low, I LOW flashes.
Note
If the Confidence Beep is on, the audible alarm
beeps if the battery has sufficient power and stops
if the battery power is low. (See the section,
“Confidence Beep.”)
Deactivating the Detector
⇒ To turn off the detector, press
F
and hold for 5
seconds.
The audible alarm beeps four times, the visual alarm flashes
four times and then the display shows:
The display turns off and the detector stops normal
operation.
Note
If F
is held down for less than 5 seconds, the
detector will not shut down.
To Next Page
Loading...
