Take out the spare wheel
1. Insert the double-headed (slotted
head) screwdriver in the attaching
tools into the opening slot (wrap a
flexible material around the slotted
head of the screwdriver to avoid
damage to the painted surface), to
open the camera cover.
2. Remove the Phillips pan head
screws with the double-headed
(cross head) screwdriver.
3. Remove the spare wheel retaining
nuts with the jack rocker assembly
in the attaching tools.
4. Remove the spare wheel.
After the spare wheel is removed; in
order to install the deflated tire into the
spare wheel cover, must remove the
cover plate and the cushion support
plate on the base and place them in the
luggage compartment.
Do not touch the camera during the removal process to avoid its damage.
Install the deflated tire
1. Raise the spare wheel cover to a
certain height, align 3 upper
protrusions with 3 protrusions on
the spare wheel base, and then
drop 3 hooks under the spare
wheel cover projections into 3
corresponding holes in the spare
wheel base, and ensure that the
hooks on both sides of the spare
wheel cover are hooked into the
corresponding holes on the spare
wheel base.
To Next Page
Loading...
