Configuration 1
Front and rear windshield wipers
The control lever is used to control the
front and rear windshield wipers and
scrubbers. The front windshield wiper is
controlled with five gears;
MIST: Jogging mode
OFF: Stop mode
INT: Intermittent mode
LO: Low speed mode
HI: High speed mode
Front windshield scrubber
■ To clean the front windscreen, pull
backward (Towards the steering
wheel) the wiper control handle so
that the scrubber sprays washing
fluid and meanwhile the wiper runs.
■ Upon release of the control handle,
the scrubber stops the spraying of
washing fluid and the wiper
continues to wipe for 2~3 cycles
and then stops.
Rear windshield wiper and scrubber
(if fitted)
■ If turning the switch knob to “ON”
position, the rear windshield wiper
will be started; if turning the switch
knob to “OFF” position, the wiper
will stop.
To Next Page
Loading...
