BYD S1 EV User Manual

3
Controller Operations
3-4 Switch
79
Configuration 2
■ The control lever is used to control
the windshield wiper and scrubber.
The lever is controlled with five
gears:

：
High speed mode

：
Low speed mode

：
Intermittent mode

：
Stop mode

：
Jogging mode
■ To select a level, pull up or push down the control handle.
■ The wiper wipes continuously at low speed and high speed positions.
■ To run the wiper under one-time wiping mode “ ”, push down the control handle
from “ ” to run the wiper at low speed, till the control handle is released.
■ Under the intermittent mode “ ”,
rotate the intermittent knob on the
wiper switch to prolong the wiping
interval along the narrowing of the
rainfall indicator bar.
Front windshield scrubber
■ To clean the front windscreen, pull
backward (Towards the steering
wheel) the wiper control handle so
that the scrubber sprays washing
fluid and meanwhile the wiper runs.
■ When the control handle is released
or the continuous running time
exceeds 10s, the scrubber stops
spraying and the wiper wipes for 1~2
cycles and then stops. After an
approximately 5s interval, the wiper
wipes once further to remove the
residual water drops from the
windscreen.

BYD S1 EV Specifications

General

Brand	BYD
Model	S1 EV
Category	Automobile
Language	English