BYD SEAL 2023 - Page 111

●
Ther
e is no vehicle network
communication failure prompt on the
instrument cluster.
●
The AEB function is not activated.
Cruise Button Operation
ACC on/o󽗈 button
Press button ① to activate or exit ACC.
(The system is in standby when activation
conditions are met). (By default, ACC
activation by pressing button ① sets the
current speed as the cruise speed. If
the current speed is below 30 km/h, the
cruise speed is set to 30 km/h.)
Resetting ACC
When the A
CC system is on standby
within the same ignition cycle, the system
memorizes the last speed setting. Push
up the lever ② to restore to the stored
speed prior to exiting the cruise system.
Increasing/Decreasing target speed
When ACC is active, set the vehicle to a
speed within the 30~150 km/h range by
moving the lever ②. Toggling the lever
② up or down each time increases or
decreases target speed by 5 km/h.
Exiting ACC
While ACC is active, pressing button ①
again or pressing the brake pedal makes
the ACC system go on standby.
WARNING
●
Ple
ase strictly abide by the speed
limit regulations of local roads,
control the speed and drive safely.
Do not overspeed.
Setting vehicle distance
●
The driv
er must select a safe vehicle
distance.
●
The system adjusts vehicle speed to
keep a suitable distance from the
vehicle ahead on the same lane.
Pressing buttons ④ and ⑤ on the
steering wheel adjusts vehicle distance
to any of the four available levels. At
each level, vehicle distance is in direct
proportion to vehicle speed. The faster
the speed, the longer the distance.
Increasing/Decreasing speed with ACC
active
●
When ACC is activated, you can press
the accelerator pedal to reach the
set target cruise speed in advance.
The system then enters over speed
mode. At the target cruise speed,
if you accelerate without performing
any other operations, the vehicle
accelerates and then returns to target
cruise speed after the accelerator
pedal is released.
●
When you press the brake pedal
with ACC activated to slow down the
vehicle, ACC goes into standby mode.
After the brake is released, ACC needs
to be reactivated.
Follow-to-stop/start
●
Controlled by ACC, the vehicle can
stop when the vehicle ahead stops in
normal driving conditions and resume
driving automatically following the
vehicle ahead if the stop is less than
30 seconds.
●
If the vehicle stops for 30 seconds to
three minutes, press the accelerator
110