WARNING
distance perceived subjectively,
especially when the objec
t is
closer to the vehicle. Assess the
distance in various ways.
●
Cameras are installed above the
front grille, side mirrors, and the
rear license plate. Make sure the
cameras are unobstructed.
●
To prevent aecting camera
performance, avoid spraying
directly on the cameras when
washing the vehicle body with
high-pressure water. Wipe any
water or dust o the camera in
time.
●
Protect the cameras from any
impact to prevent damage or
malfunction.
●
After the vehicle is powered on,
if you press the panoramic view
start button or shift into reverse
while the infotainment system is
not fully activated, the output on
the panoramic view screen will
be delayed or the screen will
ash. This is a normal part of the
camera power-on process.
Parking Assist System
●
During v
ehicle parking, the parking
assist system detects obstacles by
sensors, and prompts the driver with
the proximity of obstacles by an image
on the infotainment touchscreen and a
speaker alarm.
●
The parking assist system helps
with reversing. Pay attention to the
environment behind and around the
vehicle during reversing.
●
When you reverse the vehicle, a
reversing image will be displayed
on the infortanment touchscreen
aut
omatically.
●
After reversing ends, the interface will
be restored.
REMINDER
●
The saf
ety lines for reversing are
only for distance reference in no-
load condition of the vehicle.
●
For your driving safety, when the
reversing image is displayed, all
buttons will be disabled except
some volume and phone related
buttons.
WARNING
●
The p
arking assist system ceases
to operate when the vehicle is
moving forward at over 10 km/h.
●
Do not place any articles within
the sensors' working range.
●
To prevent sensor malfunction, do
not wash the sensor area with
water or steam.
Reversing Radar Power Switch
●
T
o enable or disable the reversing
radar system, go to Infotainment
touchscreen
→ ADAS → Parking
A
ssist.
●
When the ignition is on and EPB is
released, the parking assist system is
enabled automatically.
132