BYD SEAL 2023 - If the Vehicle Needs Support

2. Remove the left trim panel of front
c
ompartment.
3. Connect one end of the red positive (+)
cable to the positive (+) terminal of the
undercharged low voltage distribution
box of the vehicle under rescue.
4. Connect the other end of the red
positiv
e (+) cable to the positive (+)
terminal of the charged low voltage
distribution box of the rescue vehicle.
5. Connect one end of the black negative
(-) cable to the negative (-) terminal of the
charged low voltage distribution box of
the rescue vehicle.
6. Connect the other end of the black
ne
gative (-) cable to an applicable
tie point (clean, unpainted, solid and
grounded metal part) of the vehicle under
rescue.
7. Start the rescue vehicle and keep it
running for a while. Then try to start the
vehicle under rescue.
8. After the vehicle under rescue starts
normally, turn o󽗈 the power of the rescue
vehicle, remove the jumper cables orderly
r
everse to connection, and put them
away.
9. Install the hood trim panel, and close
the hood.
WARNING
●
Connec
ting or disconnecting
jumper cables in the wrong
order may lead to an electrical
short circuit, resulting in vehicle
damage or personal injury.
●
To prevent a short circuit in the
jump start, jumper cable clamps
shall not contact each other or
any conductive material other
than the jumper points.
CAUTION
●
If the v
ehicle being rescued
cannot be started after several
attempts, contact a BYD
authorized dealer or service
provider.
●
The battery rated voltage of the
rescue vehicle for jump start shall
be 12 V.
If the Vehicle Needs
Support
If the v
ehicle needs to be lifted or jacked,
the lifting arm or jack can only be placed
at the lifting points as shown in the 󽗉gure.
194