BYD SEAL 2023 - Memory System*

●
Mo
ve the rear end of the switch up or
down to raise or lower the seat.
●
Move the rear end of the switch up or
down to adjust the height of the seat
cushion.
② Seatback angle adjustment switch
●
Toggle the the seatback angle
adjustment switch front and back to
adjust the seat back angle.
REMINDER
●
R
eleasing the switch stops the
seat in this position. Do not
place anything under the seat as
this may prevent the seat from
operating.
Lumbar support adjustment*
The seatback pro󽗉le can be adjusted to
󽗉t the curvature of the occupant's lumbar
spine.
●
Press the front or rear portion of the
switch to increase or decrease the
curvature.
●
Press the upper or lower portion of the
switch to extend the curvature up or
down.
Memory System*
Memor
y switch position
The memory system switch is located on
the trim of driver door, having a total of 2
memory positions.
Setting function
●
Memory setting conditions
●
The vehicle is powered on with no
vehicle speed.
●
Seats and side mirrors have been
adjusted to the required positions.
●
No actions are performed by the
seats and side mirrors.
Memory setting method
●
Memory setting in OK mode
●
Press and release the "SET" button
on the seat memory switch, and
press either "1" or "2". Then the
positions of the seats and side
mirrors will be remembered, and the
memory setting 󽗉nishes.
●
Press and release the "SET" button
on the seat memory switch, and
press either "1" or "2" within 3
seconds. Then the positions of
the seats and side mirrors will
be remembered, and the memory
setting 󽗉nishes.
If the position button on the memory
switch has already been set, the position
set will be overwritten.
59
03
CONTROLLER OPERATION