BYD SEAL 2023 - Vehicle Towing and Flat Tire Procedures

WARNING
●
This v
ehicle uses high voltage
DC power supply. The system
can generate high heat before
and after the vehicle is started
or powered o󽗈. Beware of high
temperatures.
●
Do not disassemble, move, or
change any high voltage battery
part or connecting wire, as the
connector can cause serious
burns or electric shock. The
orange cables are part of the high
voltage harness. Users must not
repair the high voltage system
by themselves. If any repair is
required, go to a BYD authorized
dealer or service provider for
repair.
●
The remote control key and
high voltage components may
harm personnel carrying medical
devices.
If the Vehicle Needs
T
owing
If the vehicle needs towing, it is
recommended to contact a BYD
authorized dealer or service provider,
a professional towing service or the
organization you joined for roadside
assistance.
CAUTION
●
Do no
t allow other vehicles to pull
your car with only ropes or chains.
Most common towing methods:
●
Fla
tbed device
●
When the vehicle is faulty and needs
towing, a 󽗊atbed trailer is the best
choice. This is because leaving a
single front or rear wheel on the
gr
ound can cause damage to high
voltage components, and leaving a
single front or rear wheel of the
vehicle in power-up mode on the
ground can cause loss of driver
assistance system sensor calibration.
Tow Hook
The ins
tallation point of vehicle tow eye is
shown in the illustration.
1. Press to start.
2. Intall the tow hook in the tow hole.
CAUTION
●
T
owing the vehicle with a towing
hook is not recommended. You'd
better contact a professional
towing service or the organization
you joined for roadside assistance.
●
Only the in-vehicle towing hook
can be used. Otherwise, your
vehicle will be damaged.
190