BYD SEAL 2023 - Page 137

by engaging brakes to the corresponding
wheels t
o help the driver control skidding
and maintain directional stability.
Traction Control System (TCS)
TCS prevents the drive wheels from
skidding during acceleration by reducing
the motor power, and, when necessary,
apply braking forces to prevent drive
wheels from spinning. It makes the
vehicle easy to start, accelerate, and
climb under adverse driving conditions.
WARNING
●
T
CS may not work e󽗈ectively in
the following situations:
●
On slippery roads, even if TCS is
working properly, it may not be
able to control the direction and
meet power requirements.
●
Do not drive in conditions where
the vehicle may lose its stability
and power.
Hill-Start Hold Control (HHC)
After the brake pedal is released, HHC
maintains brake pressure for one second
to prevent backward sliding.
Hydraulic Brake Assist (HBA)
When you press the brake pedal quickly,
HBA detects that the vehicle is in
emergency condition. It quickly increases
the brake pressure to the maximum so
that ABS can intervene more quickly and
shorten the braking distance e󽗈ectively.
Controller deceleration parking (CDP)*
for parking brake
When you engage the EPB, the CDP
function starts working so that the vehicle
brakes at a constant deceleration (0.4 g
if EPB is engaged but the brake pedal is
not pressed, and 0.8 g if EPB is engaged
and the brake pedal is pressed) until the
vehicle stops. The function stops working
when the EPB is r
eleased.
ESC operation instructions
Intelligent power braking system has the
following new functions compared with
the original ESC system:
●
Brake assist mode
●
It is used to adjust the brake pedal
feel. The relation curve between the
brake pedal depth and the vehicle
deceleration varies across di󽗈erent
modes for you to choose a preferred
pedal feel.
●
You can select Comfort or Sport
in infotainment touchscreen
→
Vehicle Settings → Smart Chassis →
Brake assist mode.
●
Comfort Parking (CST)
●
Comfort parking: When the vehicle
decelerates to stop in a non-
emergency situation, intelligent
power braking system reduces the
stop-instant suspension pitch and
impact by controlling the brake
pressure of the four brakes, and
provides a smooth stop feeling.
●
Go to the infotainment touchscreen
→ Vehicle Settings → Smart
Chassis t
o enable or disable comfort
parking.
●
After the function is triggered, the
braking distance may increase by 2-5
cm, so increase the distance from the
vehicle or obstacle ahead accordingly
before stopping your vehicle.
●
Brake disc wiping
●
Brake disc wiping function: When the
wiper switch is on or the rain sensor
detects rain, the integrated brake
control system applies a small brake
pressure to all four brakes so that
pads come into contact with discs
to remove the water 󽗉lm from the
136