EasyManua.ls Logo

BYD SEAL EV - Remote Start Function

BYD SEAL EV
206 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
a motor release sound from the
electrical parking brake system.
The vehicle cannot power on when
The vehicle cannot power on when:
The smart key warning light lights
up, there is a beep, and a "No key
detected” message is displayed on
the cluster, meaning the key is not in
range or cannot be detected.
When the key is somewhere
unsuitable for detection, such as on
the 󽗊oor, in the cup holder, trunk,
etc, it cannot start the vehicle either.
Pressing the Start/Stop button may not
enable the start function due to:
The electronic smart key does not
work, the smart key system warning
indicator on the combination
instrument 󽗊ashes, and the message
"Low key battery" is displayed on
the information display screen in
the middle of the combination
instrument, indicating that the key
battery may have run out. Replace
the electronic smart key battery as
soon as possible with reference to
the operation procedure given in
"Smart Key Battery Runs Out" in the
section of "7-1 When Failure Occurs".
Except for above-mentioned causes,
the PEPS system also fails to work
normally under some conditions due
to di󽗈erent service environments.
Refer to "PEPS System" in the
chapter of “3 - Operation of
Controller” for relevant details.
Emergency Starting Vehicle method
Engage the parking brake 󽗉rmly.
Turn o󽗈 all lights and accessories.
The gearshift lever is on "P".
Switch the ignition o󽗈.
The electronic smart key is in the
vehicle.
Press and hold the smart key start
button for over 15 seconds.
Check after starting
Instrument cluster: Verify that
maintenance indicator and
speedometer work properly.
Brakes: In a safe area, make sure the
direction is not deviated when braking.
Other abnormalities: Check for loose
parts, leaks, and unusual noises.
If everything is OK, just enjoy your
driving.
Remote Start Function*
Electronic Smart Key Remote
Start Function
1. Press and hold the remote start/stop
button on the electronic smart key for
2 seconds to start the vehicle. After it is
started, turn signals 󽗊ash 3 times.
2. If there is no valid operation within 10
minutes after remote start, the vehicle
stops and powers o󽗈, and turn signals
󽗊ash twice.
104

Table of Contents

Related product manuals