BYD SEAL EV - Memory System; Heating and Ventilation Systems

Memory System*
Memory switch position
The memory system switch is located on
the trim of driver door, having a total of 2
memory positions.
Setting function
• Memory setting conditions
•
The vehicle is powered on with no
vehicle speed.
•Seats and side mirrors have been
adjusted to the required positions.
•No actions are performed by the
seats and side mirrors.
Memory setting method
• Memory setting in OK mode
•Press and release the "SET" button
on the seat memory switch, and
press either "1" or "2". Then the
positions of the seats and side
mirrors will be remembered, and the
memory setting 󽗉nishes.
•Press and release the "SET" button
on the seat memory switch, and
press either "1" or "2" within 3
seconds. Then the positions of
the seats and side mirrors will
be remembered, and the memory
setting 󽗉nishes.
If the position button on the memory
switch has already been set, the position
set will be overwritten.
Memory wake-up function
Memory wake-up function in OK mode
• With the gearshift lever in the "P"
position, the driver's seat memory
system will perform memory wake-up
operation when the memory system
switch is pressed if the following
conditions are met:
•The vehicle is not in anti-theft mode.
•No speed.
•Memory switch signals are valid.
•No actions are performed by the
seats and side mirrors.
Heating and Ventilation
Systems*
• To enable or disable the heating
& ventilation function, go to
Infotainment touchscreen
→ A/C
→ Seat Operation.
• Tap "Drop-down" on the home page
of the infotainment system to operate
the seat heating and ventilation setting
buttons.
Heating system adjustment
• Seat heating: Control the operation
mode of the heating pad by using
the seat heating switch. The heating
function has two modes.
•After each power-on, the driver's
seat remembers the last mode,
and the initial heating state of the
passenger's seat is O󽗈.
•Press the switch to select the
operation mode of the seat heater in
the 1st gear or 2nd gear.
•Press the OFF gear to deactivate the
heating function.
Ventilation system adjustment
• Seats Ventilation: Control the
operation mode of the ventilation fan
by using the seat ventilation switch.
Seat ventilation has two modes.
63
03
CONTROLLER OPERATION