BYD SEAL EV - Folding Rear Seats; Rear Seat Head Supports

•After each power-on, the driver's
seat remembers the last mode, and
the initial ventilation state of the
passenger's seat is O󽗈.
•Press the switch to select the
operation mode of the seat
ventilation in the 1st gear or 2nd
gear.
•Press the OFF gear to deactivate the
ventilation function.
Ventilation and heating functions
cannot be turned on at the same time.
• Press the ventilation switch to make
the ventilator work; if the heating
switch is then pressed, the ventilator
will stop and the heater will start to
work.
•
Press the heating switch to make the
heater work; if the ventilation switch is
then pressed, the heater will stop and
the ventilator will start to work.
Folding Rear Seats
Pull up the folding release clasp on the
seat back to fold the rear seat back.
REMINDER
• Fold or recover the rear seat in
a normal speed to avoid quickly
falling down or pulling up the
back seat, which may damage the
seat belts or cause abnormality.
• Ensure that the left and right
seat belts expose when folding
REMINDER
or recovering the rear seat to
avoid the seat belts being stuck
between the rear seat and the
󽗊anks.
Rear Seat Head Supports
Lifting head supports
Lift the head support to a proper position,
and release it after hearing a locking
sound.
Lowering Head Supports
Press and hold the head support
adjustment button, lower the head
support to a proper position, and release
the button after hearing a locking sound.
Removing the head support:
Press and hold the head support
adjustment button, remove the head
support, and release the button.
Installing Head Supports
Insert the head support pole into
the bushing with the grooves facing
forward. Press and hold the head support
adjustment button, lower the head
support to a proper position, and release
the button after hearing a locking sound.
REMINDER
• To avoid neck injury and other
head injuries, adjust the height of
64