BYD SEAL EV - Energy Regeneration Settings

• The set driving range display mode is
memorized by the system. When the
vehicle is powered o󽗈 and then on,
the display mode set last time will be
maintained.
REMINDER
• Driving Range Display Mode
Settings:
•The driving range that is
displayed after a full charge may
vary, depending on calculations
of the energy consumed the last
time the vehicle is used.
•The displayed driving range is
adjusted based on whether the
A/C is on, selection of driving
mode, and the driver's driving
habits, so that this range can
be closer to the estimated
remaining range under current
use.
Energy Regeneration
Settings
Energy regeneration: In this process,
the motor will generate reverse torque
when the vehicle is decelerating, and the
generated energy will be recovered and
reused to improve the energy utilization
rate of the vehicle.
• Brakes regeneration:
•When the vehicle is running in D
position, if you completely release
the accelerator pedal and depress
the brake pedal, and the vehicle is
in a stable state, priority is given
to responding to motor regeneration
for deceleration during braking
and deceleration. When the motor
capacity is insu󽗋cient, the hydraulic
brake will actively intervene to
maintain the deceleration demand
of the vehicle, and the generated
energy will be recovered to improve
the vehicle economy.
• Sliding recycling:
•When the vehicle is running in
D position, if you release the
accelerator pedal below a certain
depth, the motor will output reverse
torque to decelerate the vehicle,
and the generated energy will be
recovered to improve the vehicle
economy.
• During the driving, energy is recovered
through regenerative brakes when
the vehicle decelerates. For higher
e󽗋ciency, do not accelerate or
decelerate the vehicle unnecessarily.
•
The energy regeneration intensity can
be set with the regenerative mode
button or the multimedia system.
•Standard: When the accelerator
pedal is released, the motor
controller recovers energy in the
standard level, and the vehicle
deceleration is in the standard level.
•High: When the accelerator pedal
is released, the motor controller
recovers more energy, and the
vehicle deceleration is high.
• The corresponding settings can be
made in
→ New Energy → Energy
Management → Energy Regeneration
Mode.
• You can select the regeneration
intensity based on the deceleration
sense when releasing the accelerator
pedal. Di󽗈erent deceleration senses
deliver di󽗈erent driving experiences.
• The set energy regeneration intensity
will be memorized. When the vehicle
is powered o󽗈 and then on, the
regenerative braking mode set last
time will be maintained.
REMINDER
• Avoid setting the energy
regeneration intensity when the
vehicle is running, as this may
92