EasyManua.ls Logo

BYD SEAL EV - Gear Shift Controls

BYD SEAL EV
206 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3. Press and hold the remote start/stop
button on the electronic smart key
for 2 seconds. The vehicle stops and
powers o󽗈, and turn signals 󽗊ash
twice.
Gear Shift Controls
The gear position of the gear actuator
is marked on the gearshift lever.
P gear is for parking. Press this button
to park the vehicle and the parking
indicator will light up. Press the brake
pedal when starting to vehicle, then
the “P” gear is switched to another
position.
CAUTION
To avoid injury, press the "P"
button only after the vehicle has
completely stopped.
Reverse gear (R) can only be used after
the vehicle stops.
Neutral gear (N) is used for temporary
stop. The Parking gear must be
engaged whenever the driver leaves
the vehicle.
"D": drive position. Shift to D position
to normally drive the vehicle.
If the shift is successful, the lever
returns to its middle position after it is
released.
Before shifting into "D", ensure that the
power switch is on "OK"
Shifting out of "P" or into "D" gear
requires pressing the brake pedal and
the UNLOCK button at the same time.
For details, see the prompt message on
the instrument cluster.
WARNING
If the motor is turned o󽗈 and
the vehicle travels for a long
time after it is in the "N"
gear, the transmission may be
severely damaged due to lack of
lubrication.
When the motor is running and
the vehicle is in the "R"/"D"
gear, always stop the vehicle by
stepping on the brake pedal, as
there is still force transmitted
from the actuator and the vehicle
can travel slowly even in its idle
condition.
If you want to shift a gear while
driving forward, do not step on
the accelerator pedal to prevent
accidents.
Never set the shift lever to "R"
or press the "P" button while the
vehicle is in motion, to prevent
accidents.
Try to avoid coasting downhill in
in "N" or "P" mode, especially if
the motor is not running.
To prevent inadvertent vehicle
movement, apply the parking
brake when the vehicle comes to a
full stop and press the "P" button.
105
04
USING AND DRIVING

Table of Contents

Related product manuals