BYD SEAL EV - Discharging Equipment

Discharging Equipment
• This vehicle features a discharging
function: vehicle to load (VTOL)
function.
CAUTION
• Do not touch any metal terminal
of discharging socket or vehicle
charge port during discharging.
• Stop discharging immediately if
there are any abnormalities such
as peculiar smell and smoke.
• See "Charging Instructions" for
charging safety warnings.
• Store the product in a cool and
dry place when it is not in use.
• When charging, do not place the
equipment in the trunk, under the
front of the vehicle, or near the
tires.
• When using the equipment,
prevent it from getting rolled
over by the vehicle, dropped, or
trampled on.
•
Never drop the equipment or
move it by pulling it directly
by its cable. When moving the
equipment, handle it with care.
• Never use the charging equipment
if the household power strip cable
becomes soft, if the charging
connector cable is worn out, if the
insulation layer is cracked, or in
case of any other damage.
• Never use the equipment
when the charging connector,
power plug, or power strip is
disconnected, broken, or there is
any sign of surface damage.
CAUTION
• For precautions concerning use of
the discharge connection device,
please refer to the precautions for
charging equipment included in
item 3 of "Charging Precautions".
• Before discharging, please
con󽗉rm the vehicle state of charge
(SOC; battery charge level) and
estimate the remaining driving
range.
• Before activating Vehicle to Load
(VTOL), make sure the external
load is o󽗈.
REMINDER
• Try to use this function when the
SOC is high.
• The VTOL function is restricted
when the vehicle SOC is low.
• The static power consumption
of the vehicle will increase if,
when the vehicle is powered
o󽗈, the VTOL connection
device is connected for an
extended period without any
output. Therefore, removing the
discharging/charging connector
when the device is not used is
recommended.
External Discharging Method
Discharging
• Before discharging, turn o󽗈 the anti-
theft mode of the vehicle.
• Unlock the charge port door, then
open the port door and cap.
• Check before discharging:
1.Ensure that the battery capacity of
the vehicle to be discharged is not
below 15%.
89
04
USING AND DRIVING