BYD SEAL EV - Electric Lock Control of Charge Port

2.Ensure the VTOL connecting device
casing is not cracked, and its plug is
free from rust or obstructions.
3.Ensure that there is no water or
foreign material inside the charge
port and that metal terminals are
not damaged and free from rust or
corrosion.
•Do not discharge if any of the above
conditions is found; otherwise, short
circuit or electric shock so caused
could lead to personal injury.
• Connect the discharge connection
device:
•
Connect the VTOL discharging
connector to the charge port and
con󽗉rm that it is connected in place.
• After the switch button* on the
discharging socket is pressed, the
socket indicator stays on (red),
indicating that the socket can be used.
•
Discharging starts:
•After the connection is made,
discharge begins and respective
information is displayed on the
instrument cluster.
Stopping discharging
• Stop discharging:
•Disconnect the load.
• Disconnect the discharge connection
device:
•With the vehicle unlocked, pull the
discharging connector out of the
charge port.
•Close the charge port cap and the
port door (see
P82 ).
• Organizing the equipment:
•Store the equipment properly when
discharging is complete.
Electric Lock Control of
Charge Port
• In order to prevent the charging
connector from being stolen, the
vehicle charge port is anti-theft during
charging and discharging. In order
to prevent the charging connector
from being stolen, the charge port
of this vehicle is anti-theft during
charging and discharging. The anti-
theft function is disabled by default.
To enable the function, go to the the
Infotainment touchscreen
→ New
energy → Charge Settings and then tap
Activate.
• Under "Working mode of charge
port electric lock", tap "Activate” or
“Disable”.
•
When the anti-theft mode of charge
port electric lock is activated, the
charging connector will lock if the user
connects the charging connector and
the four doors, hood and trunk lid are
locked. To disconnect the connector,
the user needs to unlock the vehicle.
Unlocking
• When the function is enabled, unlock
the vehicle and unplug the charging
connector during charging in the
following ways:
•When it is on OFF status, press the
unlock button on the smart key to
unlock.
•Press the microswitch next to the
exterior handle of the driver's side
door to unlock.
90