BYD SEAL EV - Maintenance Rules; Tire Inflation

After washing the vehicle, rinse the
blade with plain water, and use special
windshield wax cleaner to remove the
wax layer on the windshield.
• Do not wash the blades directly with
a water jet to prevent excessive water
pressure from damaging the blades.
Maintenance Rules
• Clean windshield and blade regularly
(preferably once a week or once every
two weeks).
• Wipe the wiper regularly (preferably
once a day or once every two days).
When using a blade to wipe the
windshield, keep the windshield fully
wet (when there is no rain, the washer
liquid must be sprayed in advance).
•
Clean the windshield with a special
windshield washer 󽗊uid.
• Promptly clean mud and insect
carcasses stuck to the windshield with
a rag.
• When there are marks on the
windshield caused by gravel,
maintenance should be carried out
timely (it is recommended that
windshield repair resin products
should be used and the windshield
should be replaced if marks are too
large or too many.)
• Replace the wiper blades regularly,
preferably once every six months.
• When cleaning the windshield, raise
the wiper arm in advance. The speci󽗉c
operation method is as follows:
1.Go to infotainment system and tap
Vehicle health → Maintenance to
enable front wiper maintenance. The
wiper is rotated down.
2.Grasp the upper end of the wiper arm
and carefully lift the wiper arm and
blade assembly.
Tires
• For safe driving, tires must be made
and sized to 󽗉t the vehicle, with good
tread and standard tire pressure.
• The following pages provide details on
how to check tire pressure, damage to
and wear of tires, and the operating
method for tire transposition.
WARNING
• Using excessively worn tires, or
with too high or low pressure,
poses a high risk of accidents.
• Follow all of the instructions in
this manual on tire in󽗊ation and
maintenance.
Tire In󽗊ation
• Keep tires properly in󽗊ated to
provide the best combination of
maneuverability, tread life and driving
comfort.
• Under-in󽗊ated tires can cause uneven
tire wear, a󽗈ect steerability and energy
consumption, and are prone to leakage
due to overheating.
• Over-in󽗊ated tires reduce riding
comfort and are prone to damage from
uneven roads. In severe cases, the risk
of tire bursting poses severe threats to
the safety of the entire vehicle. Over-
in󽗊ation will also cause uneven wear
and tear of tires, a󽗈ecting tire service
life.
• When tires are cold, you can decide
whether to replenish tire pressure
according to the tire pressure values
displayed on the instrument cluster.
• Tire pressure should be measured
while tires are at ambient
temperatures. This means that it
should be measured at least three
hours after stop. If you must drive
the vehicle before the tire pressure is
173
06
MAINTENANCE